diff --git a/Yet Another Test Suite/README.md b/Yet Another Test Suite/README.md
index 3141e45..d3b043e 100644
--- a/Yet Another Test Suite/README.md	
+++ b/Yet Another Test Suite/README.md	
@@ -20,7 +20,7 @@ Yet Another Test Suite is a suite of tests for calibrating your 3D Printer. The
 
 ## Bridge Test
 
-![An example of poor 3D Printed Bridging](http://blog.ansonbiggs.com/content/images/2018/08/poorBridging.jpg)
+![An example of poor 3D Printed Bridging](https://blog.ansonbiggs.com/content/images/2018/08/poorBridging.jpg)
 
 The two major factors that come into play when printing a good bridge are **Temperature** and **Print Speed**. The lower both of these respective values are the better your bridges are likely to succeed. The goal of this project is that its a test that prints very fast, the full test should print in under 45 minutes.
 
@@ -28,7 +28,7 @@ This model is fully parameterized if you have Inventor.
 
 #### Continued 
 
-[View the full writeup On my Blog](http://blog.ansonbiggs.com/yet-another-test-suite-bridging-test/)
+[View the full writeup On my Blog](https://blog.ansonbiggs.com/yet-another-test-suite-bridging-test/)
 
 [View this Project on my Thingiverse](https://www.thingiverse.com/thing:3036666)
 
@@ -38,7 +38,7 @@ This model is fully parameterized if you have Inventor.
 
 ## Stringing Test
 
-![Poor-vs-Good-Stringing](/content/images/2018/08/Poor-vs-Good-Stringing.png)
+![Poor-vs-Good-Stringing](https://blog.ansonbiggs.com/content/images/2018/08/Poor-vs-Good-Stringing.png)
 
 The two major factors affecting stringing are **Retraction** and **Temperature**. Too high of a Temperature would cause a host of other issues in your prints so if you are mainly just experiencing stringing then Retraction is probably your issue. The included .stl tests stringing from 0mm to 15mm by default. Small strings often referred to as hairs are very common at small distances and are very easy to clean up after the print has finished. If stringing is prominent on the longer distances then I would look into the troubleshooting steps.
 
@@ -54,7 +54,7 @@ The two major factors affecting stringing are **Retraction** and **Temperature**
 
 ## Overhang Test
 
-![underView1](/content/images/2018/08/underView1.jpg)
+![underView1](https://blog.ansonbiggs.com/content/images/2018/08/underView1.jpg)
 
 No one likes using supports so it is essential to know the limitations of your printer so you can use a minimal amount of support and still get great looking models. This model tests 3 different kinds of overhangs in one. It tests concave, convex, and flat surfaces so you can see how your printer is able to do each one. Generally, concave overhangs print better than convex so this print is great for visualizing this. The idea behind this is that printing outside of parametric models usually has very weird shapes which normal flat tests don't test for.